Crown-Molding Repair in Columbus, Ohio

Transit & Flow Group repairs crown molding throughout Columbus and Central Ohio: separated seams, damaged corners, and the gaps that open up along the ceiling line as older homes settle. This is ceiling-level trim repair, not baseboard work at the floor, even though the carpentry technique is similar. Describe the damage and send photos through the Estimate Builder for a preliminary online estimate.

Is this the right service for you?

This page covers repair of existing crown molding at the ceiling line: seams that have separated, corners that have cracked or pulled apart, and gaps from house settling, which is especially common in older Central Ohio homes where the house has moved a little every year for decades. Crown molding sits where the wall meets the ceiling, a different plane and location from baseboard, which sits where the wall meets the floor. The techniques, such as coping, mitering, and filling settling gaps, are similar, but this page is specifically about ceiling-level trim, not the floor-level trim on our Baseboard Repair page.

If your crown molding damage is extensive enough that repainting the room is also on the table, crown molding repair pairs well with our Trim Painting service, a separate page, so the repaired sections blend in with a fresh coat rather than standing out as a patch. If you are dealing with baseboard instead of ceiling trim, see Baseboard Repair. If it is a small non-trim carpentry item, see Minor Carpentry.

How pricing works

Crown molding repair is fixed pricing per repaired section, priced by the linear foot of the affected run plus a base charge per repair location for setup and profile matching.

• What changes the price: the height of your ceilings (higher ceilings and stairwells need more setup and ladder work), the profile size and complexity of your existing crown molding, how many separate sections or corners need repair, and whether the repaired section needs paint matching afterward.
• Settling gaps that reopen along a long run sometimes need more than a simple caulk fill. If the molding itself has pulled away from the framing, we address the fastening, not just the visible gap, so the fix holds.
• Bundling with Trim Painting, when repainting is also needed, is priced as a combined line so you are not paying for two separate setups.

As general market context, HomeAdvisor and Angi report crown molding installation running roughly $4 to $23 per linear foot depending on material and profile, with labor alone commonly $3 to $12 per linear foot, and a typical full installation project averaging around $1,301. Spot repair of a section is priced by the affected feet and generally costs less than treating an entire room. Enter your project details and photos in the Estimate Builder for a preliminary online estimate. Final scope and price subject to verification on site.

What’s included

• Removal of the damaged crown molding section only
• New material matched to your existing profile and height where available
• Re-coping or re-mitering corners to close gaps cleanly
• Re-fastening loose sections to the wall and ceiling framing, not just filling the visible gap
• Caulking and nail-hole filling for a paint-ready finish
• All workmanship is backed by a 1-year labor warranty on labor, parts, and equipment covered per manufacturer terms.

What’s not included

• Baseboard repair or installation, which is floor-level trim covered on separate pages
• Full-room repainting; ask about bundling with our Trim Painting service if the room needs it
• Full-room crown molding replacement where damage is extensive; we will tell you honestly if your project has grown into that scope
• Water damage remediation, mold assessment, or structural ceiling repair; these are flagged separately and handled by appropriately qualified professionals where required

Crown molding repair around Central Ohio

Crown molding gaps from settling are especially common in the older housing stock of Clintonville, German Village, and Bexley, where plaster walls and ceilings have moved gradually for a century. Seams that were tight when the house was built have often opened a hairline or more at the corners, and older crown profiles in these neighborhoods tend to be taller and more ornate than what is typically stocked today, which is part of why matching the profile is its own step in the repair.

Homes in Dublin, New Albany, and similar newer developments generally have straighter, more standard framing, so crown molding gaps there are less common and usually smaller when they do appear. Across both older and newer homes, ceiling-level gaps are sometimes mistaken for a drywall problem when the actual cause is the molding pulling away from the framing as wood and house alike shift with the seasons. Diagnosing which one it is, and fixing the fastening rather than only the visible gap, is the difference between a repair that holds and one that reopens in a year.

Our process

1. Send photos of the separated seams, damaged corners, or gaps, along with ceiling height, through the Estimate Builder for a preliminary online estimate.
2. We confirm the repair is ceiling-level crown molding rather than baseboard or another trim issue, so it is on the right page.
3. On-site verification of the extent of the damage and whether the molding itself has come loose from the framing, with final pricing confirmed before work begins.
4. Removal of the damaged section, re-fastening as needed, installation of matched material, and finish work.
5. Final walkthrough to confirm the repair blends with the surrounding crown molding.

Services completed by appropriately qualified professionals where required.